- Pervasive change to automatically connect to known board types
- Lots of additional changes along with this:
- More exposure of objects/properties to Qml
- Much restructuring in LinkManager and LinkManager clients

- Pervasive change to automatically connect to known board types
- Lots of additional changes along with this:
- More exposure of objects/properties to Qml
- Much restructuring in LinkManager and LinkManager clients

- Pervasive change to automatically connect to known board types
- Lots of additional changes along with this:
- More exposure of objects/properties to Qml
- Much restructuring in LinkManager and LinkManager clients

Link ids were being used interchangeably with the mavlink channel for
the link. Link ids handed out as a numerically increasing integer. Once
the counter went past MAVLINK_COMM_NUM_BUFFERS all hell would break
loose and cause memory corruption.

Also many LinkManager API changes to further isolate all link
management inside LinkManager.

Also fixed a typo (copy/paste error) in the TCP link settings loading where it was using the UDP port as the default value instead of the TCP port.

I noticed that some times, the disconnect signal would get to the updateConnect button (tool bar) before the link was physically disconnected. That would cause it to count it as a still connected link and get the connect button logic out of sync.
While at it, added an interface to the UDP link to return its configuration instance. That allows the LinkManager to unlink it when disconnecting it.

The goal of this first installment is to organize the code a bit so it's more readable,
clean up a bit of left over cruft, and manage link configurations (and links in general).

Centralize all connecting and disconnecting of links through
LinkManager::[Connect|Disconnect]Link api. Connect/Disconnect no longer
allowed through LinkInterface. This allows creation of new
LinkManager::setConnections[Suspended|Allowed] methods to disallow
connections as needed.

This api doesn’t make any sense given the fact that LinkInterface
signals bytesReceived with the bytes in the signal. Also the reason why
it is never called!

Renamed getNominalDataRate to getConnectionSpeed. Also added upstream/downstream data rate functions to all Link classes.

Removed LinkInterface methods which were never being called. Updated various LinkInterface implementation classes to remove the methods. Some methods such as the ones which measure data rates or bits sent/received were implemented in only some of the implementation classes, and in some cases implemented incorrectly. If they were called, the values returned would be incorrect. Although there was some partial implementation for these I removed them as well since in all case they were never being called by any code. In checking Blame, these came across in 2010 and have remained unimplemented since them, so I figure better to clean up than leave crufty, unused, half finished stuff in.

Addition of requestReset to LinkInterface, to allow MavLinkProtocol to detect when connected, but at the wrong baud rate, request a reset.

Changed many functions in the abstract *Link classes to be const. This facilitates setting other functions as const. The metadata for specific links are reset when the links are added.

Changed many functions in the abstract *Link classes to be const. This facilitates setting other functions as const. The metadata for specific links are reset when the links are added.

Cleaned up communication structure significantly, should now be easier to add new links. Signal bytesReceived(link, QByteArray) is now only way to pass on newly received data