From bb855cc2fc877f01a7aeb1a038db59fa9391f82c Mon Sep 17 00:00:00 2001 From: PX4BuildBot Date: Fri, 5 Jun 2020 01:13:01 +0000 Subject: [PATCH] Update PX4 Firmware metadata Fri Jun 5 01:13:01 UTC 2020 --- src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml b/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml index 098f8feaa..00b381dc1 100644 --- a/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml +++ b/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml @@ -8696,9 +8696,9 @@ is less than 50% of this value Hz true - + Cutoff frequency for angular acceleration (D-Term filter) - The cutoff frequency for the 2nd order butterworth filter used on the time derivative of the measured angular velocity, also known as the D-term filter in the rate controller. The D-term uses the derivative of the rate and thus is the most susceptible to noise. Therefore, using a D-term filter allows to decrease the driver-level filtering, which leads to reduced control latency and permits to increase the P gains. A value of 0 disables the filter. + The cutoff frequency for the 2nd order butterworth filter used on the time derivative of the measured angular velocity, also known as the D-term filter in the rate controller. The D-term uses the derivative of the rate and thus is the most susceptible to noise. Therefore, using a D-term filter allows to increase IMU_GYRO_CUTOFF, which leads to reduced control latency and permits to increase the P gains. A value of 0 disables the filter. 0 1000 Hz @@ -8706,7 +8706,7 @@ is less than 50% of this value Low pass filter cutoff frequency for gyro - The cutoff frequency for the 2nd order butterworth filter on the primary gyro. This only affects the angular velocity sent to the controllers, not the estimators. Doesn't apply to the angular acceleration (D-Term filter), see IMU_DGYRO_CUTOFF. A value of 0 disables the filter. + The cutoff frequency for the 2nd order butterworth filter on the primary gyro. This only affects the angular velocity sent to the controllers, not the estimators. It applies also to the angular acceleration (D-Term filter), see IMU_DGYRO_CUTOFF. A value of 0 disables the filter. 0 1000 Hz @@ -10052,9 +10052,10 @@ How often the sensor is readout Enable HITL/SIH mode on next boot - While enabled the system will boot in Hardware-In-The-Loop (HITL) or Simulation-In-Hardware (SIH) mode and not enable all sensors and checks. When disabled the same vehicle can be flown normally. + While enabled the system will boot in Hardware-In-The-Loop (HITL) or Simulation-In-Hardware (SIH) mode and not enable all sensors and checks. When disabled the same vehicle can be flown normally. Set to 'external HITL', if the system should perform as if it were a real vehicle (the only difference to a real system is then only the parameter value, which can be used for log analysis). true + external HITL HITL and SIH disabled HITL enabled SIH enabled -- 2.22.0