From a8270a4416221fda8aae914872ab77a1c5049b49 Mon Sep 17 00:00:00 2001 From: PX4BuildBot Date: Wed, 5 Aug 2020 07:12:10 +0000 Subject: [PATCH] Update PX4 Firmware metadata Wed Aug 5 07:12:10 UTC 2020 --- src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml b/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml index 304c6c924..c79eee69c 100644 --- a/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml +++ b/src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml @@ -790,9 +790,9 @@ Set to 2 to use heading from motion capture Camera trigger pin - Selects which FMU pin is used (range: AUX1-AUX6 on Pixhawk controllers with an I/O board, MAIN1-MAIN6 on controllers without an I/O board. The PWM interface takes two pins per camera, while relay triggers on every pin individually. Example: Value 56 would trigger on pins 5 and 6. For GPIO mode Pin 6 will be triggered followed by 5. With a value of 65 pin 5 will be triggered followed by 6. Pins may be non contiguous. I.E. 16 or 61. In GPIO mode the delay pin to pin is < .2 uS. + Selects which FMU pin is used (range: AUX1-AUX8 on Pixhawk controllers with an I/O board, MAIN1-MAIN8 on controllers without an I/O board. The PWM interface takes two pins per camera, while relay triggers on every pin individually. Example: Value 56 would trigger on pins 5 and 6. For GPIO mode Pin 6 will be triggered followed by 5. With a value of 65 pin 5 will be triggered followed by 6. Pins may be non contiguous. I.E. 16 or 61. In GPIO mode the delay pin to pin is < .2 uS. Note: only with a value of 56 or 78 it is possible to use the lower pins for actuator outputs (e.g. ESC's). 1 - 123456 + 12345678 0 true -- 2.22.0