// Help text which is shown both in the status text area prior to pressing a cal button and in the
// pre-calibration dialog.
readonlypropertystringorientationHelp:"If the orientation is in the direction of flight, select None."
readonlypropertystringboardRotationText:"If the autopilot is mounted in flight direction, leave the default value (None)"
readonlypropertystringorientationHelpSet:"If the orientation is in the direction of flight, select None."
readonlypropertystringorientationHelpCal:"Before calibrating make sure orientation settings are correct. "+orientationHelpSet
readonlypropertystringcompassRotationText:"If the compass or GPS module is mounted in flight direction, leave the default value (None)"
readonlypropertystringcompassHelp:"For Compass calibration you will need to rotate your vehicle through a number of positions. Most users prefer to do this wirelessly with the telemetry link."
readonlypropertystringcompassHelp:"For Compass calibration you will need to rotate your vehicle through a number of positions."
readonlypropertystringgyroHelp:"For Gyroscope calibration you will need to place your vehicle on a surface and leave it still."
readonlypropertystringaccelHelp:"For Accelerometer calibration you will need to place your vehicle on all six sides on a perfectly level surface and hold it still in each orientation for a few seconds."
readonlypropertystringlevelHelp:"To level the horizon you need to place the vehicle in its level flight position and press OK."
readonlypropertystringairspeedHelp:"For Airspeed calibration you will need to keep your airspeed sensor out of any wind and then blow across the sensor."
readonlypropertystringstatusTextAreaDefaultText:"Start the individual calibration steps by clicking one of the buttons above."
// Used to pass what type of calibration is being performed to the preCalibrationDialog
propertystringpreCalibrationDialogType
readonlypropertystringstatusTextAreaDefaultText:"Start the individual calibration steps by clicking one of the buttons to the left."
// Used to pass help text to the preCalibrationDialog dialog